«

7.25″ gauge ‘JESSIE’ 0-4-0 saddletank Locomotive

If you are looking for a smaller 7.25″ gauge model which is easier to move around and will fit in many types of vehicle then this ‘JESSIE’ will meet these requirements.

Built to the Ken Swan design this model is just 33″ long and will negotiate curves down to as little as eight feet. Like the Polly 3 this model has seen very little use having been carefully stored for much of its life.

I have been through the model and it runs nicely on compressed air but is awaiting renewal of the boiler paperwork, although I have past paperwork from Nottingham club. The model has a mechanical lubricator for the cylinder lubrication and an axle pump and injector for the water feed. Plumbing is also provided to allow filling of the boiler from an external source, either a hand pump or by a mains water feed. The paintwork is not of the best but to repaint the saddletank and cab would be all that is required to improve the appearance considerably of this model.                                                                                                                                                                                £3995.00IMG_1666 IMG_1667   IMG_1670 IMG_1671IMG_1668IMG_1669 IMG_1672 IMG_1673 IMG_1674 IMG_1675